MPOS Till Control

Auto Refresh

If this option is checked on, the system will refresh the till details periodically. How often the refresh occurs depends on the Minutes setting. The task can be started in auto-refresh mode by running the command MERCHANTPOS TILLCONTROL REFRESH 5, where 5 is the number of minutes before a refresh will occur.

Show These Transactions

These icons indicate the type of tills to show. The icons work as filters. If you click on an icon, it will be greyed out and any matching tills will be removed from the grid.

Location

The code and name of the location the till belongs to.

Till

The code of the till.

Status

The Status column reflects the state of each till:

Status Date

The time the last status message was updated.

Last POS Trans

The time a POS transaction was received for this till.

Last Msg Check

The last time the POS checked for update messages.

Last Reload

The time the last reload was done.

Last Config Reload

The time the last configuration reload was done. A full reload also counts as a configuration reload.

Version

Current version of POS being used. Details are updated each time the POS does a reload.

Local Server

Indicates if the POS is connecting to Merchant Local Server for held transactions. Details are updated each time the POS does a reload.

Trans Not Sent

Number of transactions not sent to head office server yet.

Message

This message will give more details on any problems that might be identified for a till.

Refresh Data

Press this button to send a full reload command to the highlighted till. When the till gets this command, it will immediately do a reload and refresh the data.

Refresh Config Data

Press this button to send a Configuration Reload command to the highlighted till. When the till gets this command, it will immediately do a configuration reload.